C200 Pneumatic Crimp Press
The C 200 is an economical table top crimp tool which takes a variety of dies. Air operated, using standard factory air (5 bar min), with a pressing capacity of up to 1200kp, this portable device allows easy and convenient change of tools and set up for different crimp contacts. Compare this to equipment from national manufacturers at twice the price.
Built to crimp in a linear up and down fashion and not like a standard scissors crimp which can wear tools out quickly, the C200 is the ideal solution for a low cost way to crimp a higher volume of wire contacts without wearing out your operators.
Built to crimp in a linear up and down fashion and not like a standard scissors crimp which can wear tools out quickly, the C200 is the ideal solution for a low cost way to crimp a higher volume of wire contacts without wearing out your operators.
Standard and Custom Dies for Wire Crimp and IDC Assembly,
Standard Dies for insulated and bare Crimp Housings
A custom 2 position die set made to specifications speeds up the production process for this double barrel connector housing
The IDC connector press-in tool set uses a lower tool block nest to hold the connector and wire in place while the operator slides the jig underneath the press-in block to complete the assembly.
115 Pleasant Street, Millis MA 02054
Tel 508 794 1283 Fax. 508 376 2505
e mail 2e@2esyscom.com
Tel 508 794 1283 Fax. 508 376 2505
e mail 2e@2esyscom.com